Ganja Maker
Member
H&G coco question
H&G coco question
H&G coco question
bump?I already use with good success.
I use RO water and my mix always ends up around 5.8 every time without having to do any adjusting.
The other night i decided to mix a batch up with tap and see how they compared.
I mix 4 gallons at a time.
First I add my silica blast @1tsp/G, then my A, wait the 15 mins. then the B, then wait.
Now my ph is coming in @ 6.7, so I add a small amount of ph down, wait a bit, and test it.
Nothing, didn't budge.
Now normally the smallest amount of ph down goes a long way, so I started small.
I repeated adding and testing a few times only to realize that, no matter how much down I kept adding it would not go lower than around 6.4.
At this point I'm thinking there's way too much ph down in this mix.
I added the last two things to the mix per my usual system so i could test and see where my EC was at.
It came in @ 1.7 my usual mix ends up @ 1.2, and this is still with the incorrect ph.
So much ph down that when I let it sit for a bit I would see a film layer on top.
Well needless to say, I dumped this batch and didn't add it to my res.
My question I guess is
Why can't I get the ph in range with the tap?
Is it only meant for Ro water?