MGT builds 6 stacked cabs(planning phase)

[MedGrowerTom]

well there ya go, theres the house part of it in sketchup, all to scale. now to do the cabs over again a lil bit cleaner, and get started modeling the other sections

 

[MedGrowerTom]

kinda where we are at now, added some possible fronts. (cab doors, and fake drawers)

 

[MedGrowerTom]

so, I don't want to build wood soil beds like last time, it cost a lot and they are heavy, grassroots fabric pots makes some nice fabric living soil beds. but they dont fit these cabs. However they do make custom sizes, and I got my quote back and I am very pleased. Here is a screen shot of a bed, however mine will be a bit smaller. 34" x 26" x 13" I'm tempted to go 12 but that may be to low.. at the bottom at attached a snipped from my quote on the dimension.

 

[MedGrowerTom]

rough draft layout of kitchen grow cabs(lettuce, tomatoes, herbs, salads, maybe microgreens)

 

[MedGrowerTom]

desk area, might to a bookcase next to it because Im running out of room to put stuff, need spot for bongs/rigs, other stuffs

 

[MedGrowerTom]

wip rough draft of the bay window area.

spot for mothers, cloner, clones, veg, other, drying, ventilation, and electrical(for everything, drivers and everything else)

 

[Rocket Soul]

Hey OP, did you nail down your lighting choice?

One thought if youre having problems deciding: try different setups in different cabs using different spectrum on each.

 

[MedGrowerTom]

not rly, I have general idea, but I'm playing around with cab sizes for all the non flower cabs, so I can work out lighting for those areas, my mother section is to small for all the clones I have coming, so reworking that section.

I do that I will be using same light setups in each of the flower cabs, the spectrum isn't so much what I'm trying to figure out, but finding a balance on price efficiency.

If I go with the panels, I am no longer looking at 9 panels, 6 might be the way, and I dont want to run 4 that hard. So prolly 6 for each flower cab. Right after I was almost settled on this, I finally found a couple nice strip options that made me rethink... So, focusing on the other cabs dimensions, and get an idea for lighting there, and then I will be back on dialing in these main lights.

I ordered a few things so far, but im not rdy to show them until a few more things arive