Pll light ventilation mother/clone room

[B rad]

Currently I'm having trouble with ventilation in my mother/clone chamber. I have a 6" can fan max fan pro used to exhaust the air from my flower room and would like to try and tie my mother chamber into it. I have a cooler guys programmable thermostat with a 120mm cpu fan laying around from a previous cabinet that I could use any ideas or suggestions would be appreciated as you can see in the pics my mother chamber is in the top right corner of my flower room it's roughly 2' by 2'

 

[Grows1234]

Build an air cooled hood for the lights, using passive exhuast for the bulbs. Put plexiglass below lights to stop heat from getting into grow space. Cut plexi so that about an inch is left uncovered at tips of bulbs. This acts as the passive intake for the light. Then Put one 80mm fan per bulb at the top of the hood above the base of the bulbs. This allows air to enter from grow area through the inch thats not covered with plexi, the air travels over the bulb, cooling it and exhausts out the top of the hood at the base of the bulbs. Your carbon filter will pull out the heat from the bulbs.This method works great. During the winter it might work too good, and you may have to lose the plexi to keep temps up in your room. Enjoy.