Everyone welcome to my new thread/grow.Thought i would share it with you guys here at ic mag havent posted a grow or thread in a while.
Now lets get down to business heres some specs on the grow.
3 rooms Flower room is 10'x9'x6' Pre Veg room is 5'x4'x6' and the mother room is 2-1/2'x3'x6'.
Info on the flower room below.
Now first i installed a 60 amp sub panel with heavy duty timer hooked to 6 outlets.For the lights and ventilation basically all the high amperage equipment.The rest of the small equipment is ran off a 20amp switch from the main.I have all the ballast outside the rooms as well as the atmospheric controller co2 tank/regulator.I put the ro system and main reservoir on the outside as well wanted to keep as much equipment outside the room as possible.
Inside the flower room i have a 12 bucket recirculating dwc system.For lighting i have 2 1khps light hung vertically in cool tubes hooked to a 747cfm vortex inline blower which pulls air from a window located inside the room and blows fresh cold air from outside directly through the cool tubes and out of the room.I have 400cfm's for intake pulling air from the same window blowing it directly through a carbon scrubber to filter out the incoming air.I have a hepa filter to clean the air inside the room.I have a dayton 465cfm blower pulling air through a scrubber to filter the air being exhausted from the room.I have a dehumidifier and humidifier inside the room to keep optimal humidity.I have my air pumps inside of a box ceiled air tight and hooked to a 70cfm fart fan blowing frsh air from outside into the airstones.This is to prevent the air pumps from blowing high levels of co2 into the root zone with the room is setting at 1500ppm co2.I have a 1/3hp chiller hooked up to controller.I think that just about raps up the flower room.
Pre veg room i have 800w mh 12 bucket recirculating dwc system.I have a 120cfm fart fan blowing air into a carbon scrubber cleaning the air in the room.I have a 12 site dwc cloner in the pre veg as well.For intake i have a 120cfm and exhaust i have 120 cfm.The mother room which is the small room has a 400w mh light and 4 buckets.I have a 1/4hp inline chiller cooling the water in the pre veg system.I have a atmospheric controller keeping the temps right around 78f.
That pretty much describes the setup now its time to post some pics!If anyone has any question just ask away.
Last edited: