What's new

LED low temp interveinal chlorosis er what!!??

LostTribe

Well-known member
Premium user
20250106_140206.jpg
20250106_140226.jpg
 

Attachments

  • 20250106_140231.jpg
    20250106_140231.jpg
    2.6 MB · Views: 11
  • 20250106_140237.jpg
    20250106_140237.jpg
    2.1 MB · Views: 16
  • 20250106_140331.jpg
    20250106_140331.jpg
    1.6 MB · Views: 17

LostTribe

Well-known member
Premium user
No exhaust running 30% fec4800 4x4 tent
Rh 62 77f.

Temp was 60. 12/12 3days
Jacks 321full strength 2.4ec 5.8ph
100 perlite. No coco bullshit.
 

Buddler

Well-known member
Veteran
1.8 in jacks for me and I run around 30 c with leds and warm nights. Heats your friend but it drives costs up. Al most better off running an Hps for heat and light. Leds aren't any cheaper to run.. good luck mate..
 

LostTribe

Well-known member
Premium user
1.8 in jacks for me and I run around 30 c with leds and warm nights. Heats your friend but it drives costs up. Al most better off running an Hps for heat and light. Leds aren't any cheaper to run.. good luck mate..
I'll go with 1.8ec for a week and see if that helps. The runtz are light green in the center of the tops so they look like they need more N??

I added a bigger oil heater that takes up the entire center of the 4x4 tent. I should be running this fce4800 in a 5x5 but the ceiling is too short. Light has been low but since I got the temp up and humidifier going I set it at 75% and I am at 2 ft over canopy. I will try to get some leaf temp readings. I will see about adjusting for night temps. They have been in the 60F range.
 

JetLife175

Well-known member
Veteran
For optimal metabolic rate, light intensity, co2, and temp need to be In range for each other. Too much light without enough heat puts the plants into photoprotection. So will low co2 with high heat and temp.
I would follow this right here.

I'm not inside your room so it's hard to really tell what's going on BUT if you switched from LED to HPS it's looking like light burn.
 

LostTribe

Well-known member
Premium user
I would follow this right here.

I'm not inside your room so it's hard to really tell what's going on BUT if you switched from LED to HPS it's looking like light burn.
No its still the LED. That is a different plant the burnt one. I just always get that happening and its similar to the crap going on with the blue dream. I am going to see about getting a controller to run the heat, humidifier and exhaust.

They are on bricks about 3 inches off the floor and in a double bucket so roots are about 6-8 inches off the floor. New tall standing oil heather right in the middle of all the buckets too. RH now at 50-70 and temps 85F., exhaust on low. Light at 75% feeding 2.4ec ph 5.8
 

LostTribe

Well-known member
Premium user
I am sticking with straight jacks 321 recipe after talking with them. They said its got low enough N that it shouldnt burn with all else good. I get it environmental factors are showing hardcore, I am coming from verticle hanging hps bare bulbs to a tiny ass tent with a gigantic tanning bed inside!

Clearly Got to dial light back to slow metabolism. Back to 50 and watch the blue dream. They barely into bud at day 8. Looked like they were a bit greener but the GDP maybe getting rust spots, she's taking off though. Strong plant.
 

LostTribe

Well-known member
Premium user
I will keep posting here for a while in hopes. I am going to get a tent controller but saw AC Infinity just released a new one that may or may not us AI. Going to have to go chat with the Dude before I grab one. Need a new fan and filter combo anyway.
 

LostTribe

Well-known member
Premium user
Outside the tent next to an hps it did great last year. Its the tent that is messing me up. Its an fce4800 in a 3x3 not a 4x4 forgot!!!!
 
Top