How to make clones

[djam]

this thread is making peat pucks stylish again
Im going to give peat pucks another go . Thanks for the informative thread
i like how you took a pic ringing the puck out of excess water , Key step .
I think i had the pucks on the wet side in the past , my mistake .

 

[420chef]

How come the tips of the leaves on the clone are cut? Whats the science behind this?

 

[djam]

How come the tips of the leaves on the clone are cut? Whats the science behind this?

it helps with wilting and helps the clones root faster in some cases .

 

[Sinecure]

Great primer! Thanks.

 

[dodo5678]

question

question

Very nice post. Thank you. I'm using a similar setup, except i'm using dip-n-grow as my cloning solution.

This is the start of the 2nd day after taking cuttings. I have sprayed the inside of the dome, kept the moisture down in the coco pellets and sprayed them a couple times a day. The temp in the dome has ranged from 65 to almost 80F depending if the heating mat is on.

The area I have them in is well insulated so I keep debating if the heat mat should be on or not. When not on the temp stays consistent at 65F. Right now I have it off 'cause the temp was 80 in the dome. When i went to check on them today, the majority of them are leaning over the look really soft and sad. Is this normal on the second day?

Since i wrote this reply i misted them pretty good and gave them each about 2-3 ml of water and allowed some fresh air in. What should I do to get them to turn around if this is not normal?

I wish i could post pics, but not sure how many posts i need before i can do that...

Please help, your time is greatly appreciated.
-dodo

 

[dodo5678]

images!

images!

woo hoo, looks like i can upload images... hope this helps.