Venting out Window - Light and Temp Control Help

[HazePhase]

Hey Friends,

I am looking for help in venting out my window.

My situation:
Ø 5x5 tent with 12 COB Vero29 V7’s – setup is upstairs and has a mini clip fan + 18 inch fan on ceiling of tent + 6” carbon filter/fan combo.
Ø I have another tent 3x3 with 2 x T5 ballasts (2foot 4bulbs) with 2 mini clip fans. 1 is blowing above down on t5’s, other is blowing on mother plant.
Anything else please ask

Both of these are venting into the same room as the tents are in. My window is taped overtop with pool liner to keep all the light out as I don’t have blinds. Therefore the window isn’t opened which is a drag because I could vent out that window and allow fresh air in.

I am looking for help with venting out my window but not allowing air in through on the side I am venting out or light. On the other side of the window there is another sliding window where I can let air in.

Right now I can’t open the window as it pushes against my pool liner and the tape starts coming off and so does my pool liner.
I am only using masking tape and painters tape which hold up fine but won’t if air is pushing against it.
I can’t use stronger tape as I can’t ruin the paint on walls.

I am looking for help on venting my tents and allowing air in while keeping all lights out.

Thank you!!!

 

[Oysters]

If I follow you, you might try thick cardboard or thin plywood with hole(s) cut to fit, say, 4" or 6" duct take-off(s) and sized to fit in the space created when you open the window, say, 6" or 8". Attach section(s) of flex duct to the collar(s) that are long enough so you can curve the flex to block light. Then re-do your pool liner.