Titan hyperion 1 with ac

[420Voyager]

Hey guys i just bought a used hyperion 1 master controller by titan controls to control my sealed room and im realizing i think i fucked up bad. The problem is that the cooling function is connected to the co2 function, so whenever the cooling/exhaust is activated co2 is turned off. I want to use the cooling function to control my ac so obviosly i dont want my co2 turned off whenever my ac kicks in. Is there anyway to make it leave the co2 on when cooling kicks in.

 

[Lazyman]

How are you going to use the Hyperion to control an AC in the first place? Only wall units and portables use 120v, and you shouldn't switch those through a controller anyway (the high a.pwrage would get the circuit.) Use a separate thermostat for the AC either way.

 

[420Voyager]

At first i was going to use a light controller with a trigger cord plugged into the hyperion but i realize at this point its simpler to use an ac thermostat. The even more annoying problem is that the hyperions max temp is 85f with a 2 degree range so if i want to run high temps with co2 its not possible. If my room ever gets over 83 degrees the cooling function kicks in turning off the co2. 83-85 degree temps are not uncommon with sealed rooms so i just dont get why they designed it to no matter what turn off co2 off over 83 degrees.