spacecase grinder wont open

[eclecticshaman]

i just grinded up a full bit in the chamber of my spacecase and now the middle chamber is stuck together. ive been trying to lossen it by hand the past hour and my hands are starting to bleed. any ideas on how to loosen it?

 

[RudolfTheRed]

1) don't grind up so much weed.

2) your hands are bleeding? you must have weak hands.

3) soak it and lose the weed but you'll have your grinder back

 

[Bubble Puppy]

Well ..get a hammer ...u know the drill...

 

[tejashidrow]

let it just SIT for a day or so... The weed will kinda LOOSEN up naturally and then the grinder will come apart... pax

 

[eclecticshaman]

yea man, when you take off the bottom kif catcher the edges are prety sharp.
but i used two plyers and screwed it off, sacrificing the visual integerity dissappointingly though

 

[FrankRizzo]

Use some iso and a cotton swab on the threads. They can get gummed up over time and then the thing can get stuck together pretty easy.

 

[RudolfTheRed]

yeah, its actually a pretty good idea to regularly clean your grinder. mostly just make sure the threads are clean like someone already said.

 

[bluebublelove]

I've seen in generic metal grinders that mimic spacecases will more often than not have very thin threads that can bend, sheer off, and in worst case, fuse them selves together.....you need a hammer a hammer a hammer to hammer them down.

 

[killedkilleryo]

i would heat the grinder with some sort of torch .it always works when working on cars when a nut is froze just torch it then loose it .or you could throw it in the freezer .heat and cold will make the metal expand and contract.

 

[SweetNightmare]

Try tapping it lightly against something wood and unscrew... always worked when mines gotten stuck..

 

[steppinRazor]

.....you need a hammer a hammer a hammer to hammer them down.

 

[sow the seeds]

Make sure you're turning it the right way too. Sounds dumb but I had a friend try to get the kif compartment off and couldn't for the life of him. Turns out he had been turning it so hard in the wrong direction (tightening) that he could never get it off. Other than that heating is probably a good idea.

 

[nycdfan042]

if it was not stripped when you screwed it back in....it should unscrew. If it doesnt then soaking it in alcohol to clean it and then wd 40 to loosen but u have weed in it..wow sounds like a big old cluster fuck