Replacing fuse panel with load center

[socialist]

Over the years I've done a lot of electrical work. Running new circuits, installing sub-panels, etc. I have never replaced a load center though. For obvious reasons I can't call a Licensed Electrician. What is the proper procedure for handling a live service line? There is no shut off between the meter and panel. I've thought about pulling the meter to do this but am worried about getting shit from the electric company in the future when they see there lock has been cut.

If you don't want to post the info for fear of someone using this info improperly you can always shoot me a PM.

 

[guyyug]

Pulling the meter is the only way to do it. Have everything ready to start working and call the electrical company and tell them you need to do some work on the main panel, that they meter needs to be pulled. When you get done, you can put it back in or let them do it. They will only be there for a couple of minutes. Around here, we can just pull the meter, do the work, and put it back in, telling them afterwards what we did and they will swing by and put a wire lock on it, no biggie.

 

[green n dank]

where im from if you cut the wire tab on the meter you get finned, usually around 400$.
depending on how nice the tech from your power provider is he might wave the fine.

 

[rives]

Better check with the utility first. Most places that I've seen, they will want a green tag from the building inspector before they will heat you back up.

 

[socialist]

Better check with the utility first. Most places that I've seen, they will want a green tag from the building inspector before they will heat you back up.

That's how it is here.

 

[socialist]

where im from if you cut the wire tab on the meter you get finned, usually around 400$.
depending on how nice the tech from your power provider is he might wave the fine.

Here they can refuse you service for up to 12 months.

 

[PrivateAero]

Around me they don't care. If you have a smart meter they'll know as soon as you pull it off.

privateaero

 

[EclipseFour20]

I have an older house...below the meter there is an access panel that was secured with a "lead seal". Inside that "sealed panel" there are 3 main 240 volt cable/lines that are "twist locked" to lines connecting to my meter.

Turn off the main switch on the panel (now there is no power going through the meter--but the main line going to the hose is live)...which you can disconnect by undoing the twist locks (keeping the live ends covered!).

Once your done--attach the main line again, but MAKE SURE THE MAIN SWITCH IS STILL TURNED OFF--until all main line connections are restored.

If you have any doubts...then hire a professional, no reason to go kaboom over weed!