Need Help Scraping Glands off Bubblebags!

[stinkfinger]

Help! guys i cant seem to find a practical way of scraping glands off my bubblebags. i followed directions from the bubblebag website and that was not to helpful either. Does anyone have any "methods" for getting all or most of their glands off the screens. It seems that I can only smeer the glands around on the screen.Any info will be appreciated Thanks

 

[3chomes]

what you using? a spoon?

 

[Guest]

You prolly are taking too much water out before you harvest. It should be like mud when you harvest from the bags. Then immediatly rinse your bags with cold water.

 

[Dkgrower]

and also move the bags in a cirkel like motion so the trics settel in the middel,
more easy to collect bigger piles

You can also use a water sprayer to make the resin move aand then collect from bigger piles

 

[Julian]

I do larger batches, but, I always just lift/"bounce" it and it basically all comes together and comes out in a large "ball" eventually.

 

[ilife]

Rinse your resin with clean water so that all the resin ends up in a pile in the middle of the bag. Then set your bag on top of a stack of paper towels or kitchen shami to absorb all the loose water from your wet resin pile. Pick the bag up and replace it on a dry spot on the stack of paper towels or kitchen shami to absorb anymore loose water. Your resin should now be like a pile of wet sand, very easy to harvest like this. Next take a plastic card or spoon and remove your wet resin and place on a dry screen and start breaking up the pile. After you have collected the resin from your bags you will always have some resin stuck in the screen that can not be reomoved unless you place a 25um bag in a empty bucket and wash out the 120u.73u.45u, into the 25u bag. Then harvest your 25u mix. Makes for a nicer 25u and a higher percentage of finished resin in the end, and no loss to the drain!!













iLiFE