mrgrowmez
Member
Hey everyone
After three or so months of lurking, asking newb questions, building and spending hard earned $$$$$. I've finally finished my closet
So I thought I would post it up here for everyone to see because of course I can't show it to anyone else and if it wasnt for the great community of I.C. this wouldnt of happened!!! oh so bittersweet. I was supposed to move over to the netherlands for a few months for some work but that fell through so now i get to grow instead.
Here we go.......
I had two single closets sitting next to eachother in our walk in closet and after some careful convincing of the other half i managed to get permission to cut these up and turn them into a humming white marijuana machine. so.......
this became ...........................................this.
First i cut out the middle partition that were keeping them from being one with a handheld jigsaw and put a 2by4 across the top for some extra support. I then patched it up with some masonite and spac filler.
I installed the 6 inch 275cfm RVK fan you can see in the picture on some regular shelf brackets with some insulation foam as a buffer in between them and the wall to stop any vibration noise.
I've got one passive intake and one active intake which uses this old bathroom exhaust fan I found.
and as far as light traps go I just got some 90deg angle PVC and painted the insides black
After three or so months of lurking, asking newb questions, building and spending hard earned $$$$$. I've finally finished my closet
So I thought I would post it up here for everyone to see because of course I can't show it to anyone else and if it wasnt for the great community of I.C. this wouldnt of happened!!! oh so bittersweet. I was supposed to move over to the netherlands for a few months for some work but that fell through so now i get to grow instead.
Here we go.......
I had two single closets sitting next to eachother in our walk in closet and after some careful convincing of the other half i managed to get permission to cut these up and turn them into a humming white marijuana machine. so.......
this became ...........................................this.
First i cut out the middle partition that were keeping them from being one with a handheld jigsaw and put a 2by4 across the top for some extra support. I then patched it up with some masonite and spac filler.
I installed the 6 inch 275cfm RVK fan you can see in the picture on some regular shelf brackets with some insulation foam as a buffer in between them and the wall to stop any vibration noise.
I've got one passive intake and one active intake which uses this old bathroom exhaust fan I found.
and as far as light traps go I just got some 90deg angle PVC and painted the insides black
Last edited: