DIY ezcloner pump/temp question

[darkhollo]

I have a 13 gallon 25 site homebrew ez cloner. I was using a submersible little giant 390 GPH pump and I feel that the temp is too high.

• 
  What are optimal temps for the water in an ez cloner?
  What pump are others using in a similar sized unit?

TIA

-dh

 

[darkhollo]

Blah, I found that sticky in the hydro forum.

Seems like 68-72 still? I guess I need to get a chiller going or a DIY water cooler.
And definitely a smaller pump.

-dh

 

[JohnnyToke]

im using a via aqua 1300 (390gph) in my diy cat litter plastic pail aero cloner and it roots just fine. my water temps inside run about 80f - 85f. roots show in 8-10 days using plain tap water. no dome used and I keep a small 11w cfl over them 24 hours a day until rooted.

hope this helps.

regards,
JT

 

[JordanTheGreat]

right now im using a 250gph propump and my temps never break eighty, usually rooted by ten days with tap water and thrive alive

 

[Pseudo]

80 degrees just like tropical fish like, go to walmart and get the tiny heater that has no dial and regulates to .....80 degrees