so I scored a blueprint dbac2 w/fuzzy logic for my grow room. it was only a couple hundred more than a lesser grade controller, so I upgraded. I could use some help in setting this thing up, as far as getting all my equipment plugged in and getting going.
what I have
14k bt portable a/c pulls 12 amps
8" scrubber fan 1.75 amps
8" intake fan 1.25 amps
deheuy 7.5 amps
co2 solenoid 2amps max???
im looking for the best possible way....and safest w/o going over rated max amps to set this up. I can plug the deheuy into its own socket (not the dbac2 if needed) and use the deheuy's on/off rh set points, or plug it into the bdac2 unit and have the unit control it. I would only need the deheuy at night/lights off. max lights off rh is 65% at 75-77* (within VDP numbers).
im currently entering week 5 of flower. so im thinking its too late to run the co2 this cycle, and have time to set this up. or run it for a couple weeks before the 7th week mark hits. read supposed to shut co2 off 2 weeks before harvest.
thanks for the help everyone.
what I have
14k bt portable a/c pulls 12 amps
8" scrubber fan 1.75 amps
8" intake fan 1.25 amps
deheuy 7.5 amps
co2 solenoid 2amps max???
im looking for the best possible way....and safest w/o going over rated max amps to set this up. I can plug the deheuy into its own socket (not the dbac2 if needed) and use the deheuy's on/off rh set points, or plug it into the bdac2 unit and have the unit control it. I would only need the deheuy at night/lights off. max lights off rh is 65% at 75-77* (within VDP numbers).
im currently entering week 5 of flower. so im thinking its too late to run the co2 this cycle, and have time to set this up. or run it for a couple weeks before the 7th week mark hits. read supposed to shut co2 off 2 weeks before harvest.
thanks for the help everyone.
