1000W Grow room advice needed

[Swiper]

Hello All!

Im curnetly in my construction phase of my grow room have a little bit more wiring to due along with some plumbing but the bump in the road im curently stuck on is this issue. Im going the bio bucket route (Thanks BT,Daltron(RIP) ) and I will be keeping my moms and clones in the same room. I need some advice on how I can partion this part of the room off from the rest (No light leaks) It has to be easily acsesiable and alow the plumbing to come thru on the lower left hand side. The only things left to do is hook up the plumbing and ventaltion and buy a few more supplies and off to a grow jorunal I GO!!!

Here is a pic of the area that needs partioned off. I was thinking a ziperable tarp of some sorts but dunno of any very light proof ones.



Thanks for the help !

(Im actully a old Icmag user under a new alias for security reasons)

 

[mrwags]

This thread will save you a ton of time and money:


http://www.icmag.com/ic/showthread.php?t=13810



Hope it helps.


Mr.Wags

 

[jojajico]

plywood doors with weather stripping? its kinda hard to tell from the pic cause of the mylar.

 

[Swiper]

Its about a 24" wide gap that needs to be sealed and the celling is at a bevel.

A little more info on the system

20 Gal Res
8 5 gallon buckets with 8" net pots
1" supply line
DIY carbon filter
1000 Watt MH/HPS switchable ballest with agromax horti bulbs
6" ducting
Fox farm nutes (organic)

This is actully a a closet you see here space is tight and in the picture is where the 2 moms will be kept , the res and pump on the bottom, and the cloning area up top. Next to that is a partioned off area (drywall) with the ballest ventlation fans and my electrical work.

I do not know about the plywood as the main supply piping comes thru on the lower left of this area and with the buckets in there will be limted room. I only have to worry about light leaving this area when the main area is in flower and there will be 4 cpf in this area.

All ideas welcome !!

Thanks for the link nice setup

 

[stonedage]

All i use is B&W poly hung from the ceiling one from the left side one from the right side so they over lap and i just walk through them and make sure when i come back out they are tight together again, i left alot on the bottom so no light come out from under and across the top o used a piece of 2X4 that i stapled the bw to. as for the moms and kids, i put them in to a encloser made out of the same BW poly and have it in the other side of the room, ive been this way for a long time and no probs at all!! very cheap and ghetto but it works. it is pitch black in my room at all times. I have to pull the plastic back just to see if the lights are on
SA