100% FIX to leaking Aerocloners

bartender187

Bakin in da Sun

Veteran

• Nov 8, 2005

• #1

If your aero-cloner is leaking, *i had alot of trouble with this*.... heres an idea a good friend figured out for me.

Basically, we have one rubbermaid container that is slightly larger than another rubbermaid container... (the larger container was originally alot taller, but a hack-saw fixed it quick.)

1) Drill a few small holes in the bottom of the smaller one

2)Take off the top of the bigger one... place the smaller one in the bigger one


3)install pump and aercloner manifold in smaller one

4)cut holes for plants in lid of the smaller one


so... when the smaller rubbermaid container leaks it will drip into the larger resevoir, and then circulate back into the small resevoir via the small holes you drilled...

 

Last edited: Nov 8, 2005

C

cropmanagement

Active member

• Nov 9, 2005

• #2

nice, where did you get those little nozzle srayer things?

 

bartender187

Bakin in da Sun

Veteran

• Nov 9, 2005

• #3

crop- the local hydro store should have em'.... these were the 360 degree models, i have yet to experiment with the spinning or 180 degree ones.

 

George Burnz

Member

• Nov 9, 2005

• #4

The Spinners Suck. They all don't spin freely. Unless your pushing major GPM's you have to mess with them often. Go for the 360's.

~GB~

 

H

HOVAH

Member

• Nov 9, 2005

• #5

now thatS a great idea!!! man i was about to give up on my aerocloner,thankyou very
much 1HOVAH

 

bartender187

Bakin in da Sun

Veteran

• Nov 9, 2005

• #6

Brunz= good to fuckin know, i was about to go pick up a batch.

HOVAH- im glad someone liked it enjoy

take care,
bartender187

 

H

hogwild

Member

• Apr 4, 2007

• #7

great idea bartender, I think im going to use a variation of your anti leak technique.. instead of poking holes in the original smaller tub im going to add a drain to the larger tub that drains to waste.... thanks for the ideas man.